AT91SAM9G20

This is latest KaeilOS / OpenEmbedded build test with AT91SAM9G20 -EK board by Atmel

BUILD

Website      : http://www.kaeilos.com
Build system : KaeilOS/OE 10-JUL-2009
Branch       : org.openembedded.dev    <-- do not use stable !
Machine      : at91sam9g20ek
Image        : console-image
Command      : MACHINE="at91sam9g20ek" bitbake console-image
SHA-1 tag    : f0d8b8301f8a3c9f8ef73b3d5a876d341b8b3370

Boot log

RomBOOT

U-Boot 1.3.4 (Dec 12 2008 - 12:18:30)

DRAM:  64 MB
NAND:  256 MiB
In:    serial
Out:   serial
Err:   serial
Net:   macb0
macb0: Starting autonegotiation...
macb0: Autonegotiation complete
macb0: link up, 100Mbps full-duplex (lpa: 0x45e1)
Hit any key to stop autoboot: 

U-Boot> print

bootdelay=3
baudrate=115200
ethact=macb0
bootargs=mem=64M console=ttyS0,115200 root=/dev/mtdblock1 rw rootfstype=jffs2
bootcmd=nand read 0x22200000 0x00200000 0x00200000; bootm 0x22200000
ethaddr=12.34.56.78.90.aa
netmask=255.255.255.0
ipaddr=192.168.0.184
serverip=192.168.0.251
stdin=serial
stdout=serial
stderr=serial

Environment size: 321/131067 bytes

U-Boot> boot

NAND read: device 0 offset 0x200000, size 0x200000
2097152 bytes read: OK
## Booting kernel from Legacy Image at 22200000 ...
   Image Name:   KaeilOS/2.6.28/at91sam9g20ek
   Image Type:   ARM Linux Kernel Image (uncompressed)
   Data Size:    1628812 Bytes =  1.6 MB
   Load Address: 20008000
   Entry Point:  20008000
   Verifying Checksum ... OK
   Loading Kernel Image ... OK
OK

Starting kernel ...

Uncompressing Linux........................................... done, booting the kernel.
Linux version 2.6.28 (koan@kaeilos) (gcc version 4.2.4) #1 Fri Jul 10 19:07:41 CEST 2009
CPU: ARM926EJ-S [41069265] revision 5 (ARMv5TEJ), cr=00053177
CPU: VIVT data cache, VIVT instruction cache
Machine: Atmel AT91SAM9G20-EK
Memory policy: ECC disabled, Data cache writeback
Clocks: CPU 396 MHz, master 132 MHz, main 18.432 MHz
Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 16256
Kernel command line: mem=64M console=ttyS0,115200 root=/dev/mtdblock1 rw rootfstype=jffs2
RCU-based detection of stalled CPUs is enabled.
AT91: 96 gpio irqs in 3 banks
PID hash table entries: 256 (order: 8, 1024 bytes)
Console: colour dummy device 80x30
console [ttyS0] enabled
Lock dependency validator: Copyright (c) 2006 Red Hat, Inc., Ingo Molnar
... MAX_LOCKDEP_SUBCLASSES:  8
... MAX_LOCK_DEPTH:          48
... MAX_LOCKDEP_KEYS:        8191
... CLASSHASH_SIZE:          4096
... MAX_LOCKDEP_ENTRIES:     8192
... MAX_LOCKDEP_CHAINS:      16384
... CHAINHASH_SIZE:          8192
memory used by lock dependency info: 2399 kB
per task-struct memory footprint: 1152 bytes
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Memory: 64MB = 64MB total
Memory: 57884KB available (2976K code, 3860K data, 132K init)
SLUB: Genslabs=12, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
Calibrating delay loop... 197.42 BogoMIPS (lpj=987136)
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
net_namespace: 352 bytes
regulator: core version 0.5
NET: Registered protocol family 16
AT91: Power Management
AT91: Starting after user reset
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 2048 (order: 2, 16384 bytes)
TCP bind hash table entries: 2048 (order: 4, 65536 bytes)
TCP: Hash tables configured (established 2048 bind 2048)
TCP reno registered
NET: Registered protocol family 1
Initializing RT-Tester: OK
JFFS2 version 2.2. (NAND) (SUMMARY)  © 2001-2006 Red Hat, Inc.
msgmni has been set to 113
io scheduler noop registered
io scheduler anticipatory registered (default)
atmel_usart.0: ttyS0 at MMIO 0xfefff200 (irq = 1) is a ATMEL_SERIAL
atmel_usart.1: ttyS1 at MMIO 0xfffb0000 (irq = 6) is a ATMEL_SERIAL
atmel_usart.2: ttyS2 at MMIO 0xfffb4000 (irq = 7) is a ATMEL_SERIAL
brd: module loaded
loop: module loaded
MACB_mii_bus: probed
eth0: Atmel MACB at 0xfffc4000 irq 21 (12:34:56:78:90:aa)
eth0: attached PHY driver [Davicom DM9161A] (mii_bus:phy_addr=ffffffff:00, irq=-1)
NAND device: Manufacturer ID: 0xec, Chip ID: 0xda (Samsung NAND 256MiB 3,3V 8-bit)
Scanning device for bad blocks
Creating 3 MTD partitions on "atmel_nand":
0x00000000-0x00400000 : "Bootstrap"
0x00400000-0x04000000 : "Partition 1"
0x04000000-0x10000000 : "Partition 2"
ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
at91_ohci at91_ohci: AT91 OHCI
at91_ohci at91_ohci: new USB bus registered, assigned bus number 1
at91_ohci at91_ohci: irq 20, io mem 0x00500000
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
usb usb1: New USB device found, idVendor=1d6b, idProduct=0001
usb usb1: New USB device strings: Mfr=3, Product=2, SerialNumber=1
usb usb1: Product: AT91 OHCI
usb usb1: Manufacturer: Linux 2.6.28 ohci_hcd
usb usb1: SerialNumber: at91
udc: at91_udc version 3 May 2006
zero gadget: Gadget Zero, version: Cinco de Mayo 2008
zero gadget: zero ready
mice: PS/2 mouse device common for all mice
rtc-at91sam9 at91_rtt.0: rtc core: registered at91_rtt as rtc0
i2c /dev entries driver
i2c-gpio i2c-gpio: using pins 55 (SDA) and 56 (SCL)
at91_mci at91_mci: 4 wire bus mode not supported - using 1 wire
Registered led device: ds5
Registered led device: ds1
usbcore: registered new interface driver usbhid
usbhid: v2.6:USB HID core driver
Advanced Linux Sound Architecture Driver Version 1.0.18rc3.
ASoC version 0.13.2
ALSA device list:
  No soundcards found.
TCP cubic registered
NET: Registered protocol family 17
RPC: Registered udp transport module.
RPC: Registered tcp transport module.
rtc-at91sam9 at91_rtt.0: setting system clock to 2009-07-10 19:26:17 UTC (1247253977)
JFFS2 notice: (457) check_node_data: wrong data CRC in data node at 0x02e46c58: read 0xb99092ce, 
 calculated 0x15c66d29.
VFS: Mounted root (jffs2 filesystem).
Freeing init memory: 132K
INIT: version 2.86 booting
Please wait: booting...
mount: sysfs already mounted or /sys busy
mount: according to mtab, sysfs is already mounted on /sys
Error opening /dev/fb0: No such device or address
makedevs: //dev/initctl: file can not be created with mknod!
Remounting root file system...
Configuring network interfaces... udhcpc (v1.13.2) started
Sending discover...
eth0: link up (100/Full)
Sending discover...
Sending select for 192.168.0.222...
Lease of 192.168.0.222 obtained, lease time 600
adding dns 151.99.125.1
adding dns 151.99.0.100
adding dns 208.67.222.222
done.
net.ipv4.conf.default.rp_filter = 1
net.ipv4.conf.all.rp_filter = 1
INIT: Entering runlevel: 5
Starting Dropbear SSH server: dropbear.
Starting syslogd/klogd: done

##    ##    ###    ######## #### ##        #######   ######
##   ##    ## ##   ##        ##  ##       ##     ## ##    ##
##  ##    ##   ##  ##        ##  ##       ##     ## ##     
#####    ##     ## ######    ##  ##       ##     ##  ######
##  ##   ######### ##        ##  ##       ##     ##       ##
##   ##  ##     ## ##        ##  ##       ##     ## ##    ##
##    ## ##     ## ######## #### ########  #######   ######(R)
KaeilOS Linux at91sam9g20ek ttyS0

KaeilOS 2008.1-test-20081222 at91sam9g20ek ttyS0

KaeilOS 2009.1-test-20090710 at91sam9g20ek ttyS0

at91sam9g20ek login: