This is latest KaeilOS / OpenEmbedded build test with FOX Board G20 (formerly known as Netus G20) by AcmeSystems.
FOX Board G20 is a Single Board Computer based on the AT91SAM9G20 microcontroller, the 400MHz ARM9 CPU made by Atmel.
BUILD
Website : http://www.kaeilos.com
Build system : KaeilOS/OE 23-OCT-2009
Branch : org.openembedded.dev <-- do not use stable !
Machine : at91sam9g20ek
Image : console-image
Command : MACHINE="at91sam9g20ek" bitbake console-image
SHA-1 tag : c8dc29972b40e70550f6c2275a307557f1c4bf30
Boot log
RomBOOT
U-Boot 2009.06 (Aug 21 2009 - 10:53:00)
DRAM: 64 MB
NAND: No NAND device found!!!
0 MiB
DataFlash:AT45DB642
Nb pages: 8192
Page Size: 1056
Size= 8650752 bytes
Logical address: 0xD0000000
Area 0: D0000000 to D00041FF (RO) Bootstrap
Area 1: D0004200 to D00083FF Environment
Area 2: D0008400 to D0041FFF (RO) U-Boot
Area 3: D0042000 to D0251FFF Kernel
Area 4: D0252000 to D083FFFF FS
In: serial
Out: serial
Err: serial
Net: macb0
macb0: Starting autonegotiation...
macb0: Autonegotiation complete
macb0: link up, 100Mbps full-duplex (lpa: 0x45e1)
U-Boot> print
bootdelay=3
baudrate=115200
bootargs=console=ttyS0,115200 root=/dev/mmcblk0p1 rw rootfstype=jffs2,ext2 rootwait
bootcmd=cp.b 0xD0042000 0x22200000 0x000BEFFF; bootm 0x22200000
ethaddr=12.34.56.78.90.aa
netmask=255.255.255.0
ipaddr=192.168.0.184
serverip=192.168.0.251
stdin=serial
stdout=serial
stderr=serial
Environment size: 368/16892 bytes
U-Boot> boot
## Booting kernel from Legacy Image at 22200000 ...
Image Name: KaeilOS/2.6.28/at91sam9g20ek
Image Type: ARM Linux Kernel Image (uncompressed)
Data Size: 1630300 Bytes = 1.6 MB
Load Address: 20008000
Entry Point: 20008000
Verifying Checksum ... OK
Loading Kernel Image ... OK
OK
Starting kernel ...
Uncompressing Linux..................................... done, booting the kernel.
Linux version 2.6.28 (koan@quad) (gcc version 4.3.3 (GCC) ) #1 Sun Oct 25 01:26:32 CEST 2009
CPU: ARM926EJ-S [41069265] revision 5 (ARMv5TEJ), cr=00053177
CPU: VIVT data cache, VIVT instruction cache
Machine: Atmel AT91SAM9G20-EK
Memory policy: ECC disabled, Data cache writeback
Clocks: CPU 396 MHz, master 132 MHz, main 18.432 MHz
Built 1 zonelists in Zone order, mobility grouping on. Total pages: 16256
Kernel command line: console=ttyS0,115200 root=/dev/mmcblk0p1 rw rootfstype=jffs2,ext2 rootwait
RCU-based detection of stalled CPUs is enabled.
AT91: 96 gpio irqs in 3 banks
PID hash table entries: 256 (order: 8, 1024 bytes)
Console: colour dummy device 80x30
console [ttyS0] enabled
Lock dependency validator: Copyright (c) 2006 Red Hat, Inc., Ingo Molnar
... MAX_LOCKDEP_SUBCLASSES: 8
... MAX_LOCK_DEPTH: 48
... MAX_LOCKDEP_KEYS: 8191
... CLASSHASH_SIZE: 4096
... MAX_LOCKDEP_ENTRIES: 8192
... MAX_LOCKDEP_CHAINS: 16384
... CHAINHASH_SIZE: 8192
memory used by lock dependency info: 2399 kB
per task-struct memory footprint: 1152 bytes
Dentry cache hash table entries: 8192 (order: 3, 32768 bytes)
Inode-cache hash table entries: 4096 (order: 2, 16384 bytes)
Memory: 64MB = 64MB total
Memory: 57896KB available (2972K code, 3860K data, 132K init)
SLUB: Genslabs=12, HWalign=32, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
Calibrating delay loop... 197.42 BogoMIPS (lpj=987136)
Mount-cache hash table entries: 512
CPU: Testing write buffer coherency: ok
net_namespace: 352 bytes
regulator: core version 0.5
NET: Registered protocol family 16
AT91: Power Management
AT91: Starting after power-restored wakeup
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
NET: Registered protocol family 2
IP route cache hash table entries: 1024 (order: 0, 4096 bytes)
TCP established hash table entries: 2048 (order: 2, 16384 bytes)
TCP bind hash table entries: 2048 (order: 4, 65536 bytes)
TCP: Hash tables configured (established 2048 bind 2048)
TCP reno registered
NET: Registered protocol family 1
Initializing RT-Tester: OK
JFFS2 version 2.2. (NAND) (SUMMARY) © 2001-2006 Red Hat, Inc.
msgmni has been set to 113
io scheduler noop registered
io scheduler anticipatory registered (default)
atmel_usart.0: ttyS0 at MMIO 0xfefff200 (irq = 1) is a ATMEL_SERIAL
atmel_usart.1: ttyS1 at MMIO 0xfffb0000 (irq = 6) is a ATMEL_SERIAL
atmel_usart.2: ttyS2 at MMIO 0xfffb4000 (irq = 7) is a ATMEL_SERIAL
brd: module loaded
loop: module loaded
MACB_mii_bus: probed
eth0: Atmel MACB at 0xfffc4000 irq 21 (12:34:56:78:90:aa)
eth0: attached PHY driver [Davicom DM9161A] (mii_bus:phy_addr=ffffffff:00, irq=-1)
nand_get_flash_type: second ID read did not match 52,52 against ff,03
No NAND device found!!!
ohci_hcd: USB 1.1 'Open' Host Controller (OHCI) Driver
at91_ohci at91_ohci: AT91 OHCI
at91_ohci at91_ohci: new USB bus registered, assigned bus number 1
at91_ohci at91_ohci: irq 20, io mem 0x00500000
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
usb usb1: New USB device found, idVendor=1d6b, idProduct=0001
usb usb1: New USB device strings: Mfr=3, Product=2, SerialNumber=1
usb usb1: Product: AT91 OHCI
usb usb1: Manufacturer: Linux 2.6.28 ohci_hcd
usb usb1: SerialNumber: at91
udc: at91_udc version 3 May 2006
zero gadget: Gadget Zero, version: Cinco de Mayo 2008
zero gadget: zero ready
mice: PS/2 mouse device common for all mice
rtc-at91sam9 at91_rtt.0: rtc core: registered at91_rtt as rtc0
i2c /dev entries driver
i2c-gpio i2c-gpio: using pins 55 (SDA) and 56 (SCL)
at91_mci at91_mci: 4 wire bus mode not supported - using 1 wire
Registered led device: ds5
Registered led device: ds1
usbcore: registered new interface driver usbhid
usbhid: v2.6:USB HID core driver
Advanced Linux Sound Architecture Driver Version 1.0.18rc3.
ASoC version 0.13.2
ALSA device list:
No soundcards found.
TCP cubic registered
NET: Registered protocol family 17
RPC: Registered udp transport module.
RPC: Registered tcp transport module.
rtc-at91sam9 at91_rtt.0: setting system clock to 2009-10-25 01:46:16 UTC (1256435176)
Waiting for root device /dev/mmcblk0p1...
mmc0: host does not support reading read-only switch. assuming write-enable.
mmc0: new SD card at address 1234
mmcblk0: mmc0:1234 SA02G 1.83 GiB
mmcblk0: p1
EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended
VFS: Mounted root (ext2 filesystem).
Freeing init memory: 132K
INIT: version 2.86 booting
Please wait: booting...
Error opening /dev/fb0: No such device or address
mount: sysfs already mounted or /sys busy
mount: according to mtab, sysfs is already mounted on /sys
Starting udev
udev: starting version 141
Remounting root file system...
Unknown HZ value! (90) Assume 100.
Configuring network interfaces... udhcpc (v1.13.2) started
run-parts: /etc/udhcpc.d/00avahi-autoipd exited with code 1
Sending discover...
eth0: link up (100/Full)
Sending discover...
Sending select for 192.168.0.222...
Lease of 192.168.0.222 obtained, lease time 600
run-parts: /etc/udhcpc.d/00avahi-autoipd exited with code 1
adding dns 151.99.125.1
adding dns 151.99.0.100
adding dns 208.67.222.222
done.
Unknown HZ value! (92) Assume 100.
net.ipv4.conf.default.rp_filter = 1
net.ipv4.conf.all.rp_filter = 1
INIT: Entering runlevel: 5
Starting system message bus: dbus.
Starting Dropbear SSH server: dropbear.
Starting syslogd/klogd: done
* Starting Avahi mDNS/DNS-SD Daemon: avahi-daemon
[ ok ]
## ## ### ######## #### ## ####### ######
## ## ## ## ## ## ## ## ## ## ##
## ## ## ## ## ## ## ## ## ##
##### ## ## ###### ## ## ## ## ######
## ## ######### ## ## ## ## ## ##
## ## ## ## ## ## ## ## ## ## ##
## ## ## ## ######## #### ######## ####### ######(R)
KaeilOS Linux at91sam9g20ek ttyS0
KaeilOS 2008.1-test-20081222 at91sam9g20ek ttyS0
KaeilOS 2009.1-test-20091024 at91sam9g20ek ttyS0
at91sam9g20ek login:
English
Italiano
